1-1/4 in.-4 in. Retro Master Flash EPDM roof flashing
8 in. x 8 in. soft aluminum base for profiled metal roofs
Easily customized to accommodate use on multiple pipe sizes
Most commonly used with an existing roof penetration， when installing a flashing over the pipe is not an option and requires a hard-to-reach or wrap-around installation
Marked cut lines allow for easy installation and customization for various pipe sizes with a sharp knife or scissors
Slide over pipe， use silicone sealant between base and surface， then secure with sheet metal screws
Flexible base conforms to most flat or contoured roof surfaces including clay tile and metal roofs， sliding over vent pipe with pitch from 0-45°
Non-fading EPDM collar provides maximum resistance to weathering caused by ozone and UV rays
Rated to withstand 212°F continuous heat and approved for Type B installations; intermittent temperature resistance to 275°F
Do not use petroleum based products on Retro Master Roof Flashings
MASTER FLASH is a Registered Trademark of the Aztec Washer Company
Comment